1 1. Light intensity: Intensity of incident solar radiation is an important parameter in any photocatalytic reaction because the rate of reaction is totally dependent on the absorption of the photocatalyst so that the degradation rate can be increased with the increase in light intensity.
2 2. Nature of the photocatalyst: Nature of photocatalyst should be adaptable to oxidation reactions. For the absorption of light radiation, the different morphologies of photocatalysts are required for higher activity and stability.
3 3. Concentration of the substrate: The concentration of a substrate is an essential parameter which is going to be of use in any photocatalytic reaction. Purity and adequate concentration is required to perform such reactions to avoid the wastage of materials.
4 4. Concentration of photocatalysts: Normally, optimum concentration of photocatalyst is decided after necessary enumeration to avoid the excess of the catalyst so that absorption of enough photons can be possible to carry out a successful photochemical reaction.
5 5. pH: The knowledge about the effect of pH in any photocatalytic reaction is beneficial to carry out the photochemical reaction because pH controls the surface charge properties of the photocatalysts.
6 6. Reaction temperature: Temperature plays an important role in the reaction rate of a photocatalytic reaction for the conversion of organic substances. It is evident from the literature that photocatalytic activity is directly affected by the reaction temperature because the increase in temperature raises the chances of recombination of charge carriers and desorption of adsorbed materials which inturn decrease in the photocatalytic activity.
1.3.4 Characterization Tests
Semiconductors are main materials to generate holes and electrons after incident radiation in heterogeneous photocatalysts. To detail the study about semiconductors it is essential to check the capability of photocatalysts. There are so many characterization tests to check the possibility for utilization of biomass by photocatalysis which are summarized below in Table 1.4. In this table, all possible characterization tests are based on elemental composition, band structures, physical and chemical properties.
Figure 1.4 provides a glimpse of strategy for the fabrication of photocatalysts which is given below [15].
There are some requirements to fulfill these strageies for the fabrication of any photocatalyst [15]:
1 Enable the catalysts to absorb maximum solar spectrum,
2 Separate or prevent the photoexcited charges,
3 Making tuning band gap to get enough energy for initiating the required reactions,
4 Modification in catalyst to get better stability,
5 Making catalyst to reusable,
6 Minimizing photocatalyst cost.
Table 1.4 Essential characterization tests on semiconductors used in photocatalysis [17].
| S. no. | Characterization tests | ||
|---|---|---|---|
| 1. | Elemental composition | ||
| (i) | Chemical composition | ||
| (a) | Energy dispersive X-ray spectroscopy | ||
| (b) | Electron energy-loss spectroscopy | ||
| (c) | High-angle annular dark-field imaging | ||
| (ii) | Chemical state and structure | ||
| (a) | X-ray photoelectron spectroscopy | ||
| (b) | |||