Lynne Shore Garcia

Diagnostic Medical Parasitology


Скачать книгу

as thick and thin films and then stained with Delafield’s hematoxylin, which demonstrates greater nuclear detail as well as the microfilarial sheath, if present. In addition, fresh thick films of blood containing microfilariae can be stained by this hematoxylin technique (Fig. 7.17 and 7.18) (4, 9).

      Figure 7.17 Wuchereria bancrofti microfilaria on a thick film stained with Delafield’s hematoxylin. Note the presence of the sheath. (Image courtesy of the CDC Public Health Image Library.) doi:10.1128/9781555819002.ch7.f17

      Figure 7.18 Wuchereria bancrofti microfilaria. (Upper) Microfilaria stained with Giemsa stain. Note that the sheath is not visible. (Lower) Microfilaria stained with Delafield’s hematoxylin stain. Note that the sheath is visible. doi:10.1128/9781555819002.ch7.f18

      Preparation of Stain

      Dissolve 180 g of aluminum ammonium sulfate in 1 liter of distilled water (saturated solution). Heat until dissolved. The cooled supernatant fluid is saturated aluminum alum.

      Hematoxylin Solution

      Dissolve the hematoxylin in alcohol, and add it to the alum solution. Expose the solution to sunlight and air for ripening in a clear, cotton-plugged bottle for approximately 1 week; then filter and add the following:

      Age for 1 month or longer in sunlight, and then run test smears to determine whether the solution is properly aged. Nuclei should stain blue, and cytoplasm should stain different shades of red.

      Procedure

      1. Prepare thick films from the concentration material or from fresh blood.

      2. Allow the films to air dry.

      3. Lake the films in 0.85% sodium chloride or distilled water for 15 min (not necessary for films prepared from the Knott sediment). Allow to air dry.

      4. Fix all films in absolute methanol for 5 min. Allow to air dry.

      5. Stain in undiluted Delafield’s hematoxylin for 10 to 15 min.

      6. Wash off excess stain in tap water.

      7. Intensify the blue color by placing the films into tap water containing several drops of ammonia (NH4OH) for several minutes.

      8. Rinse again in running tap water for 5 min.

      9. Air dry.

      10. Mount in Permount or some other mounting medium; use a no. 1 coverglass.

      References

      6. Garcia LS (ed). 2010. Clinical Microbiology Procedures Handbook, 3rd ed, vol 1, 2, and 3. ASM Press, Washington D.C.

      7. Kokoskin E. 2001. The Malaria Manual. McGill University for Tropical Diseases, Montreal, Canada.

      10. Shute PG. 1966. The staining of malaria parasites. Trans R Soc Trop Med Hyg 60:412–416. PMID 4162149