The Wildlife-friendly Garden. Michael Chinery

tend to be rather wasteful of this lining material.

       WHICH WATER SOURCE?

      The tap is usually the only source of water for the pond. The high mineral content of tap water may encourage the algae to multiply rapidly and turn the water green in the summer, but this will not harm the wildlife of the pond and the algae will gradually dwindle as they use up the minerals. The best thing, if you are planning to have a pond, is to store up a supply of rain water ready for filling it. Always use rain water to top up your pond in the summer: an adaptor fitted to a drainpipe can be used to divert water into a hose leading to the pond.

      Acres Wild

      A) Moisture-loving shrubs, such as guelder rose and alder buckthorn, can be planted around the pond, but do not let them shade the water

      B) Free-floating plants, such as frogbit, provide shade for many small animals

      C) The floating leaves of yellow water lily and similar plants make good landing pads for dragonflies

      D) Large stones breaking the surface provide perches for drinking birds and basking spots for frogs

      E) A sloping ‘beach’ makes it easy for animals to get in and out of the pond

      F) Wetland plants, such as marsh marigold, provide food and shelter for insects and many other small creatures

      G) The flexible liner can be covered with fine soil here and there to allow plants to root naturally

      H) Submerged plants, such as curled pondweed and water milfoil, maintain oxygen levels

      I) The jetty can be supported on building blocks, but these should be set on rubber or plastic pads to protect the liner

      J) Native marginal plants, such as arrowhead and flowering rush, can be planted in the swampy area at the edge. They give a natural effect and provide cover for many animals

      

       PROTECT YOUR LINER

      Before installing the liner, remove any sharp stones that you can see and then line the hole with soft sand to protect the liner. You can also buy polyester matting specifically made for this purpose. Alternatively, you can use old plastic bags, as used for potting compost, but an old carpet is even better.

       Acres Wild/Ian Smith

      1 Decide on the shape and size of your pond and mark it out with a rope or a hose-pipe before you begin digging. Make the pond as big as you can, but ensure that you can get a liner of a suitable size before you start work!

       Acres Wild/Ian Smith

      2 Make sure that the edges of the pond are perfectly level, otherwise the liner will be exposed in some places. The central area should be at least 50cm (20in) deep to ensure that the whole pond does not freeze solid in a hard winter.

       Acres Wild/Ian Smith

      3 It is best to start digging in the centre and then slope the bottom gently up to the surface. Leave a flat shelf about 15cm (6in) below the final water surface on one side, so you can grow marginal plants there in pots (see here).

       Acres Wild/Ian Smith

      4 It’s now time to install the liner by spreading it over the hole and pushing it roughly into position. Weight the edges down with something heavy, ensuring that there is at least 25cm (10in) overlap all round the margin. Then you can start adding the water. As it runs in, the weight of the water stretches the liner and moulds it to the shape of the hole.